SynQor unveils the MilCOTS 3-Phase MPFCQor Power Factor Correction module which is an essential building block of an AC-DC power supply. Used in conjunction with one of SynQor’s matched 3-Phase AC line filters and a limited amount of stabilizing capacitance, this MPFCQor will draw well-balanced and low-distortion sinusoidal currents from each phase of a 3-Phase AC input. It is designed to comply with a wide range of military standards and is manufactured in the United States.
Operational Features
- Large-module form factor
- 5.0 kW continuous rating at 80 °C baseplate temperature
- Semi-regulated output: 400 Vdc
- Compatible with Military Standard 60 Hz, 400 Hz & var. freq. systems
- Meets military standards for harmonic content
- Drives pulsed output loads without passing transients back to the input
- Minimal inrush current
- Balanced phase currents
- High power factor (0.999 at 60 Hz / 5.0 kW)
- Minimal external output capacitance needed
- Supports full load current during startup ramp
- Additional input filters available to meet full EMI
- N * 5.0 kW power levels when paralleled
Control Features
- All control pins referenced to the separate floating return
- Asynchronous serial data interface
- AC and DC Power Good outputs
- PFC Enable and Battle Short inputs
- 3.3 V always-on standby power output
- Clock synchronization output
Compliance Features
3-Phase PFCQor series converters are designed to meet:
(With an MCOTS 3-Phase AC input filter)
- MIL-STD-461 (C, D, E, F)
- MIL-STD-1399 (at 440 Vrms L-L)
- MIL-STD-810G
Protection Features
- Output current limit and auto-recovery short circuit protection
- Auto-recovery input under/over-voltage protection
- Auto-recovery output over-voltage protection
- Auto-recovery thermal shutdown
